Once fully cured Tec7 is resistant to oil and sea water making it ideal for use on boats and area’s where oil will be a factor.
Tec7 is Airtight > 0.2m³/m²
This depends on the size of the bead being dispensed but an accurate guide would be a 5mm bead will get you linear 12mtrs from a cartridge.
Tec7 forms a dry skin type coating after approximately 20 minutes which allows it to be painted using most common paints available on the market.
Tec7 is available in White, Black, Grey, Beige, Light Oak, Brown & Terracotta. Tec7 is also available in TRANS CLEAR and a unique TRANS Metallic/Chrome colour.
Each colour is easily identified by the colour of the nozzle on the cartridge.
Tec7 can be reused as often as you need to for up to 12 months after your first use. Simply re-attached the cap provided on to a cleaned nozzle and store it in a dry and frost-free location. *Please note, Tec7 will cure approximately 1cm into the nozzle, this is perfectly normal and is actually protecting the rest of the product in the cartridge.
Tec7 is resistant to all the above, a helpful tip, if using to seal around a shower or bath, do not lick your finger to try and finish the bead, this will only transfer bacteria from your tongue on to the product, we recommend you use spray Tec7 Cleaner or similar product on to the Tec7 first.
As Tec7 is completely solvent free, it is ideal for use on mirrors etc. as unlike solvent based products, it will not eat into the back of the mirror which causes the black speckles commonly seen on mirrors.
Yes, Tec7 is food safe and can be used to bond, mount or seal in area’s where food is prepared etc.
Tec7 is an MS Polymer based product so does not contain any solvents making it virtually odourless and environmentally friendly.